Journal of Advanced Chemical Engineering

Benefits of recycled polymers obtained from the paint industry on mechanical properties and durability of concrete structures

2^nd World Congress on Biopolymers

August 04-05, 2016 Manchester, UK

Joseph Jean Assaad

Notre Dame University, Lebanon

Posters & Accepted Abstracts: J Adv Chem Eng

Abstract:

Polymeric virgin latexes such as styrene-butadiene rubber and vinyl acrylic homo- or copolymers are widely used in repair and patching works to increase adhesion and bond strengths of cementitious-based materials to various substrates. These have found particular acceptance in reinforced concrete applications due to their superior resistance to corrosion, chloride ion penetration, as well as oxygen diffusion. Because of economical and environmental considerations, the recycling of waste polymers resulting from the paint industry during concrete production has considerably increased over the last years. In fact, virgin polymers are key ingredients in latex-based paints; these are mixed with the pigment/extender powders and stabilized in water with the addition of thickening and dispersing agents. The paints shelf lives are relatively short (up to one year), generating large amounts of waste materials; in the United States, this is estimated around 16 to 35 million gallons per year, about which 5% to 10% ends up in landfills. Existing literature shows that recycled polymers resulting from waste latex paints enhanced plain (i.e., unreinforced) concrete properties, mainly flexural strength given the high tensile strength of latex films associated with bond improvement at the hydrated paste-aggregate interfacial transition zone. Limited studies investigated the effect of recycled polymers on reinforced concrete properties including the bond stress-slip with embedded steel bars and whether such behavior would be similar to that imparted by virgin polymeric latexes. Around fifty concrete mixtures containing different vinyl acrylic-based polymer concentrations are tested by direct bond and beamend methods. Test results have shown that the concrete-bar interfacial bond stresses occurring during the elastic region substantially improved with recycled and virgin polymers. At similar polymer-to-cement ratio, concrete incorporating recycled polymers exhibited improved bond properties than mixtures prepared with virgin ones. This was indirectly related to the pigment and extender powders in the waste latex paints, thus reducing porosity and improving denseness of cement paste that strengthen the transition zone adjacent to reinforcing bars. The effect of reducing water-to-cement ratio while adding superplasticizer to compensate the loss in workability and compressive strength was found efficient to increase the ultimate bond strength.

Biography :

Email: jassaad@ndu.edu.lb